Filter
Top Products
Reset to Factory Settings
You can reset your unit to factory settings for Start-Up mode,
volume, drk,aud,cty and Selectable Features.To reset,press
and hold the cty button until the display shows “
RESET”.
Two “beeps”will sound and your unit will cycle through the
Normal Start-Up Mode.
Voltage War ning
Your bel 980 or bel 950continually check your vehicle’s voltage
to ensure proper performance of your detector.The unit’s
operating range is 10.5 to 16.0 volts.If voltage falls below 10.5
volts,display will show “
LOW VOLT” until condition is rectified.
drk (Bright/Dim/Dark) Button
The drk button allows selection of a bright,fully adjustable
dim mode or dark mode.The unit is factory preset to full
bright display.To engage dim mode,press and hold the drk
button.The display will cycle through various levels of dim
illumination.Release the button at your chosen level.To
engage dark mode,press the drk button a second time.A
single “beep”coupled with the brief illumination of“DARK”
on the display confirms your selection.You’ll notice an “H”
(Highway mode) or “C”(City mode) remains dim to confirm
your unit is receiving power.To return to a full bright setting,
press the drk button a third time;two “beeps”confirm this
selection.Use of the drk button does not affect audio alerts.
Important—if you press the the drk button and do not receive
audible confirmation, the audio level has been set too low.
aud (Auto-Mute/Volume Control) Button
Manual Muting of Audio Alerts (Radar and sws
™
)
Whether Auto-Mute is selected on or off in Selectable
Features,the audio alerts can be completely muted by
pressing the aud button during an alert.The display will
briefly show “
Qu ie t .” No audible alert will be heard for
approximately 12 seconds.If the signal is still present after 12
seconds,the unit will remain in manual mute mode.
Note—because Laser alerts are not lengthy or sustained,
muting is not required (see page )