Filter
Top Products
12
© 2013 Directed. All rights reserved.
Valet take-over (optional)
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
on the remote
control (or press and release the optional momentary switch).
Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will stay run-
ning.) The engine will run until the pre-programmed time elapses
or a shut-down input is received.
This feature will not work if the brake pedal is being pressed.
Note
If vehicle is equipped with push button start, consult dealer
for instructions.
Disabling the remote start system
This feature allows your system’s remote start unit to be temporarily
disabled to prevent the vehicle from being remote started accidentally.
This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the shutdown toggle
switch to the On position. The switch can be installed in a location
of your choice.
Note
Consult your local 12-volt retailer for the location of Toggle
switch.