Filter
Top Products
P. 6 User Guide
delivery or at a convenience store, lock your vehicle and leave it running for the length of
a run cycle while you are away.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission
:
1. With the engine running, press the LOCK or UNLOCK button (to unlock the doors)
or the START button on the remote control until the parking lights come on.
2. Remove the key and exit the vehicle. The engine will go on running.
3. Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of
the Engine Run Time.
If your vehicle has a manual transmission
, Idle Mode can be activated through the
same routine as that used for Ready Mode; at the last step, the
TRUNK button is pressed
instead of the other buttons:
1. Ensure that all the Doors are closed and that the Shifter is in the Neutral
position.
2. With the Engine already running, apply the Parking Brake and release the
Brake Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. Push LOCK, UNLOCK or START on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press the TRUNK button until the system is armed (the doors will be locked if
remote door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will get in Ready Mode.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
Valet Modes
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the
engine from being remote-started accidentally.
To put the system into Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec. press the Valet button and release it, the Parking lights will flash
3 times. Turn the IGNITION OFF, the LED will come ON. (The system is in Valet
Mode.)
To take the system out of Valet Mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec. press and release the Valet button, the Parking Lights will flash
tiwce. The LED will go OUT. (The system is out of Valet Mode.)
The Valet button can only be used if the ignition key is in the IGNITION ON (RUN) position.