Filter
Top Products
P. 4 User Guide
Basic Remote Operation
This system is equipped with a 5-button multi-channel transmitter. It can operate two in-
dependent identically-equipped vehicles (see Multi-Car Operation for second-car
transmitter functions).
The functions of the transmitter are as follows:
Note: Pressing the
LOCK and UNLOCK buttons at the same time will activate the AUX 2 output.
Remote-starting Your Vehicle
If your vehicle has an automatic transmission, simply press the START button to remote
start your vehicle. Skip the next steps on to “Remote-starting”.
Warning: If you vehicle has an automatic transmission and the parking lights flash 15
times after pressing the
START button, the parking brake is connected to ground. It is
imperative that you see your installer and have him disconnect the wire.
Setting Your Vehicle into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In
order to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is
not set to Ready Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake,
depending on the option that was selected by your installer. Therefore, you must follow
the appropriate procedure between the two described below in order to set your vehicle
into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at
any time. The system will exit Ready Mode if a door, the hood or the trunk is opened, if
the brake pedal is pressed, if the parking brake is disengaged or if the ignition key is
turned to the
IGNITION ON (RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
LOCK: Locks the doors and arms
the STARTER KILL. Triggers Panic
if pressed more than 3 seconds
TRUNK: Opens the TRUNK or
activates the AUX 3 output
STOP: Stops the engine if pressed
for less than 3 seconds or triggers
Panic mode if pressed for more than
3 seconds.
UNLOCK: Unlocks the doors
and disarms the STARTER
KILL. Activates the AUX 2
output if priority door access
is configured.
Triggers Panic if pressed
more than 3 seconds
START: Remote starts the
engine or gets the system
into Cold Weather mode if
p
ressed for 3 seconds.