P. 14 User Guide
Parking Lights Flash Rate (Normal Operation)
Flashes Description
1
• Doors locked, Alarm and starter kill armed.
• Run time has expired.
•
TRUNK button pressed.
• Start signal received by the module.
• Cold weather mode cancelled.
2
• Remote start attempt cancelled by remote.
• Doors unlocked, starter kill disarmed.
• Exiting ignition valet
• Power ON to OFF(Automatic
transmission)
• Exiting remote valet
• Power-up reset.
• Board set from manual to automatic;
power ON
2 slow flashes then
8 quick flashes
• Reset from Manual to Automatic
3
• Entering ignition valet
• Entering or exiting Ready Mode
• Entering remote valet.
• Entering extended run time
4
• +12 V detected on the brake input wire
either while cranking or during run time.
• Entering multi-speed tach programming.
• Board set from automatic to manual; power
ON
• Power ON to OFF ( manual transmission)
5 Fast
• Tach signal programmed.
• New transmitter programmed.
6
• A remote start was attempted while a tach-before-crank signal was detected before cranking.
8
• Unit reset
10
• A ground (-) signal was detected on the hood pin input wire.
When pressing START
15 quick flashes
• The parking brake is connected to ground (automatic transmission)
1 – pause – 2
• There was a remote start attempt while the vehicle was in valet mode.
• Failed start: vehicle’s low battery voltage.
…followed by 1 flash
• Exiting cold weather mode
ON SOLID for 3
seconds….
…followed by 3 flashes
• Entering cold weather mode
ON continuously
• Idle mode: Idle mode is engaged
• Run time: The vehicle has been remote started and is in run time.
ON 2 seconds
• The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds
• Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds
• The hood pin has been flashed and you now have access to the programming options.
Constant flashes
up to 60 sec.
• In Siren or Horn Mode: Alarm condition generated by an intrusion, or when the System is
powered up.