Filter
Top Products
The engine will go on running. It will shut down when the pre-programmed run time expires.
Caution: Do not leave children or pets unattended in a car running
in Idle Mode.
Note: When enabling Idle Mode, pressing LOCK or UNLOCK will
unlock the doors (if Remote Door Locks are installed).
Turbo Mode
When programmed (at the time of installation), this Option allows turbochargers to idle down: after
the user leaves the vehicle, the Engine will keep running for 60 sec. And shut down.
Proceed as follows to activate Turbo Mode:
1. With the Engine already running press LOCK on the Transmitter until the Parking Lights come
on.
2. Remove the key: the Engine will go on running.
3. Exit the vehicle and close the Door.
4. Press the TRUNK button to lock the Doors and shut down the Engine after 60 sec. running
in Turbo Mode.
“Home Valet” ™ Mode
This safety feature will remotely place the vehicle into a no-remote-start mode: if the vehicle is
parked indoors there is no danger it will start accidentally by remote control or external trigger.
To e n t e r Home Valet Mode:
x Press LOCK or UNLOCK on the Transmitter.
x Within 5 seconds, press LOCK + START: the Transmitter will display the “Valet” icon
and you will hear a beep.
To e x i t Home Valet Mode, turn the ignition key to the IGNITION ON (RUN) position.
Note: Once Home Valet is activated, the vehicle will not start by remote control or external
trigger until the ignition key is turned to the IGNITION ON (RUN) position.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting i n t o Valet Mode
x Hold the UNLOCK and START/STOP buttons simultaneously for 3 seconds.
x The Parking Lights will flash 3 times.
The Transmitter will BEEP once and will display the icon; the LED will remain on solid.
Getting o u t of Valet Mode
x Hold the UNLOCK and START/STOP buttons simultaneously for 3 seconds.
x The Parking Lights will flash 2 times.
The Transmitter will BEEP once and the icon will disappear; the LED will turn off.
Note:
With the Remote Valet activated, the
remote starter function will be disabled.
Ignition Valet
This feature allows the user to enter Valet Mode by using only the Ignition key. It may need to be
programmed, please refer to the Options Programming section in the Installation Guide to find out.
AS-2500 TW User Guide P.9