Filter
Top Products
P. 14 User Guide AS-2500 TW
Diagnostics – Parking Lights Flash Rate (Normal Operation)
Flashes Description
1
x Doors locked, Starter Kill armed.
x End of Run Time.
x
TRUNK button pressed
x Start signal received by the Module.
x Cold Weather Mode cancelled.
x Cannot start after maximum number of attempts is reached.
2
x Remote start attempt cancelled by remote.
x Run Time cancelled.
x Doors unlocked, Starter Kill disarmed.
x Exit Remote Valet
3
x Entering Cold Weather Mode.
x Entering Remote Valet.
4
x +12 V where detected on the brake line and cranking was cancelled.
x Entering Tach-learning Mode
5
x New Transmitter learnt.
x Tach learnt.
6
x A remote start was attempted while a Tach or a vacuum signal was detected before
cranking.
8
x Unit reset: occurs when the Unit is reset to the factory defaults.
10
x The Hood Switch line went to ground during cranking or Run Time.
1 – pause – 2–
pause – 2
x There was an attempt to start the vehicle while the Module was in Home Valet™.
1 – pause – 2
x There was an attempt to start the vehicle while the latter was in Valet Mode.
2 – pause – 3
x Get into Cold Weather Mode when in Safe Start Mode.
2 – pause – 1
x Exit Cold Weather Mode when in Safe Start Mode.
ON solid
x Cold Weather Mode: the Brake Pedal is being held down (automatic-transmission
models only). Entering Idle Mode and Turbo Mode.
ON 2 sec.
x The Hood is up and the Hood Switch line went to ground. This is step one of the
Programming Modes.
ON 3 sec.
x First press of the START button under Safe Start.
ON 4 sec.
x Locking or unlocking a Door (with Door pulses configured to 4 sec.)
ON 25 sec.
x If the Hood Pin-switch has been pressed twice (down-up / down, up): the Unit
went into step 1 of the Programming cycle and no Transmitter activity was detected
for 20 seconds
x Or the Unit went into step 1 of the Transmitter Code Learning procedure and no
activity was detected for a few seconds. The Unit has exited the Transmitter Code
Learning procedure.
Irregular
x If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by
further flashes), the system is playing back event-logging codes. This occurs when
the Hood Pin-switch is pressed three times (down-up / down-up / down-up)
Constant flashes
up to 30 sec.
x Panic Mode.