Filter
Top Products
P. 24 Installation Guide
c. Press the push button switch until the Parking lights flash twice.
d. Release the push button and turn the ignition to the OFF position.
The LED on the antenna will flash quickly to indicate that the vehicle is now out of
Valet mode.
Panic Mode
Note: Panic mode can only be activated if the horn option has been adequately installed
and programmed by the installer. Button Ι has to be programmed as LOCK and
UNLOCK.
In an emergency situation, the user can activate panic mode by pressing and holding the Ι button
for approximately 3 seconds until the horn honk starts and the parking lights flash. This will:
• shut down the engine
• unlock or lock the doors (with the
Ι button)
• disarm the Starter Kill and
• activate the horn for 25 sec.
Panic Mode will automatically shut down after 25 sec.
Note: To stop panic mode before the end of its delay, press the Ι button until the sound
signal stops.
The AUX 1 / Horn Output
¾ Horn Confirmation:
AUX 1 can be programmed to trigger the horn upon locking the doors with the transmitter. When
horn confirmation is activated, panic mode is enabled. If horn confirmation is disabled, panic mode
will not be available, but constant while pressed of
LOCK/UNLOCK will be activated.
The Trunk Output
This 500 mA negative output gives a 1-second pulse when the Ι & ΙΙ buttons are pressed together
(if the ignition is
OFF or during a remote start).
Ready Mode Option
If the vehicle has a manual transmission, please read the following indications. In order to start
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected. Therefore, you must follow the appropriate procedure between
the two described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking
brake, press and hold Ι or ΙΙ on the
-