Filter
Top Products
Installation Guide P. 15
Note: To exit programming mode, close the hood.
Note: To exit programming mode, press on the
antenna button once (the LED will come ON) and
release.
Remember: You can use the programming Assistance button instead of the
hood pin at any time the hood is up.
The Programming Assistance Button (a.k.a. PAB)
The PAB is located
on the side of the
module. This push
button mimics the
hood-pin switch in
order to avoid having
to get out of the
vehicle and pressing
the hood-pin switch.
The PAB will work
only when the hood
is up.
Once inside the programming options, the installer has a selection of many different sub-menus:
a) Transmitter Programming
b) Programming Options
c) Honk Horn Timing* (*if available)
d) Tach Programming
Manual or Automatic Transmission
This module may be installed on vehicles with manual or automatic transmissions. It is originally
configured for manual transmissions
. If the vehicle you are working on is automatic, it is mandatory
to make a few quick and easy modifications before the unit is connected. In the event that the
configuration requires changes afterwards, a complete reset will be necessary before those
changes become effective.
To install this unit in a vehicle with a manual transmission:
1. Make sure the Yellow loop on the PC board is connected.
2. Connect the Black/White handbrake wire located on the 12-pin harness to the vehicle
handbrake switch.
3. Connect the Violet (+) door input OR
the Green (-) door input wire located on the 12-pin
harness to the vehicle door pin wire, which monitors all the doors of the vehicle (only
use 1 of the 2 door trigger inputs).
4. Make sure the Violet/White TACH wire is plugged in – the TACH wire MUST be hooked
up when the module is set for a manual transmission.
5. Make all your regular connections.
6. Power up the unit by first inserting the 5-pin connector, then the 6-pin connector and
finally the 12-pin connector. The parking lights will flash 4 times to confirm that the unit
is in manual mode.
7. When learning the transmitter, the parking lights will flash 5 times quickly, confirming
that the module is set to manual mode.
8. Upon the first successful remote start, the system will lock the transmission
settings to manual mode.