Filter
Top Products
AS-1820 FM Installation Guide P. 3
Introduction
This Guide contains all the information relevant and necessary for the installation of the
Remote Car Starter. Most of the features of this product are explained in the User Guide.
Therefore, if you need detailed information about a feature of the product, we recommend
that you refer to the User Guide.
Included in the Kit
Please carefully read the Installation Guide before beginning the installation, especially the
Harness Description section and the Programming Options.
It is very important that you familiarize yourself with the programming and the operation
of the Remote Car Starter, even if you have already installed a similar Remote Car Starter
in the past. There are many innovative features that you may overlook if you do not read this
Guide.
Prior to the installation, make sure that all the hardware components required to install the
system are in the box.
The following is a list of components included in the kit:
• 1 – Remote Car Starter Control Unit
• 1 – FM long-range Receiver with LED incorporated
• 2 – multi-channel 5-button transmitters
• 1 – six-pin 14 AWG Harness (Ignition Harness)
• 1 – five-pin 18 AWG Harness (Main Harness)
• 1 – twelve-pin 22 AWG Harness (Accessories Harness)
• 1 – two-pin 22 AWG Harness (Accessories Harness)
• 1 – parts bag: a Hood Pin-switch, a Connector and a Warning Label
• 1 – User Guide
The plug-in Valet button is not included with this Remote Car Starter.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that required for successful communication.
FCC USER NOTICE:
The manufacturer is not responsible for any radio or TV interference caused by
unauthorised modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
Installation Points to Remember
Ƈ Make sure that vehicles equipped with an
automatic Transmission do not start while in
any of the Drive Gears. If the vehicle
starts in gear, install a Manual-
transmission Remote Starter instead.
Ƈ When installing a manual-transmission
product on a vehicle with a manual
Transmission, always make sure that all
Doors will get the Unit out of Ready Mode.
Switch the wire used so that it is triggered
by all Doors.