Filter
Top Products
P. 18 Installation Guide AS-1820 FM
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2. Press and release the Break Pedal 6 times (within 13 seconds from entering
Programming Mode).
3. The Parking Lights will flash 8 times to confirm resetting.
Table 8: Resetting without a Valet Button
On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if
the Brake Pedal is pressed while the Ignition Key is not in the
IGNITION ON (RUN) position: you
will need therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test
lead at the Brake Pedal switch.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2. Press and release the Valet Button 6 times or more until the Parking Lights start to
flash.
3. The Parking Lights will flash 8 times to confirm resetting.
Table 9: Resetting with the Valet Button
Events Logging
With this feature, the Remote Car Starter will play back the last 4 Start Failure Events
Codes and the last Intrusion Code via the Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
OFF.
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push the Pin-switch 3 more times
(down-up / down-up / down-up).
The Parking Lights and L.E.D. will flash the five events stored in memory.
Table 10: Events playback
The first four playback codes are Start Failure Events, while the last playback code is an
Intrusion Code. There is a pause after each event code is played back.
The system will play back the most recent event first, then the second one, and so on. If
there is no event at all to report, the Parking Lights will give one long flash.
To jump directly the Intrusion Code, press the Brake Pedal. Close the Hood tso end
playback.
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected, or Tach before Start
Note: “x” stands for one flash of the Parking Lights