Filter
Top Products
AS-1820 FM Installation Guide P. 11
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
• LOCK..................to access Mode 1;
• UNLOCK..............to access Mode 2;
• TRUNK................to access Mode 3.
The Parking Lights will flash and the horn will honk once, twice or three times to
confirm entry into a Mode (if it has been configured).
3. Release the Brake Pedal.
Table 3: Accessing modes
Note
The Unit will stay in the selected programming
Mode until the Hood Pin-switch or the Brake Pedal
is pressed again. Therefore take your time to
make the proper selection. Pressing the Brake
Pedal will take you back to the Programming
Centre, where you can select a different Mode.
Once you access a particular programming Mode, you will automatically start at Function 1.
Once you select one of the Options of Function 1, you will automatically be taken to the next
Function.
To select one of the four Options of any given Function, press the corresponding button
on the Transmitter:
• LOCK button .........................to access Option 1
• UNLOCK button .....................to access Option 2
• TRUNK button .......................to access Option 3
• START/STOP button ...............to access Option 4
Table 4: Accessing options
In each Function, once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4
times (depending on the selected Option).
Please note that the different Functions within any particular Mode can only be accessed
sequentially: the Programming Centre will move from Function 1 to Function 2, then to
Function 3, and so on. Therefore, whenever you access a particular Mode, be prepared to
re-configure all the Functions of that Mode in ascending order.
Programming Options
MODE 1 * INDICATES DEFAULT SETTING
FUNCTION 1 – Ignition-controlled Door Locks
OPTION 1* Ignition Lock DISABLED
OPTION 2 Ignition Lock ENABLED
OPTION 3 Ignition UNLOCK ONLY
OPTION 4 Ignition LOCK ONLY
FUNCTION 2 – Secure Lock
OPTION 1* Secure Lock DISABLED (1-sec. Disarm pulse)
OPTION 2 Secure Lock ENABLED in Smart Mode
OPTION 3 Secure Lock DISABLED (1/2-sec. Disarm pulse)
OPTION 4 Secure Lock ENABLED in Standard Mode