Filter
Top Products
AS-1725 SH Installation Guide P. 19
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected, or Tach before Start
Note: “x” stands for one flash of the Parking Lights
Diagnostics – Parking Light Flash Table
Flashes Description
1
x Doors locked, Starter Kill armed.
x End of Run Time.
x
TRUNK button pressed
x Start signal received by the Remote Car Starter.
x Cold Weather Mode cancelled.
x Cannot start after maximum number of attempts is reached.
2
x Doors unlocked, Starter Kill disarmed.
x Run time cancelled.
x Remote start attempt cancelled by remote.
3
x Entering Cold Weather Mode.
x Entering extended run time.
4
x +12 V where detected on the brake line and cranking was cancelled.
x Entering Tach-programming Mode
5
x New Transmitter programmed.
x Tach programmed.
6
x A remote start was attempted while a Tach or a vacuum signal was detected
before cranking.
8
x Unit reset: occurs when the Unit is reset to the factory defaults.
10
x The Hood Switch line went to ground during cranking or Run Time.
1 – pause – 2
x There was an attempt to start the vehicle while the Remote Car Starter was
in Valet Mode.
ON solid
x Cold Weather Mode: the Brake Pedal is being held down.
2 – pause – 2
x There was an attempt to start the vehicle while the Remote Car Starter was
in Home Valet Mode.
ON 2 sec.
x The Hood is up and the Hood Switch line went to ground. This is step one of
the Programming Centre procedure.
ON 3 sec.
x First press of the
START button under Safe Start.
ON 4 sec.
x Locking or unlocking a Door (with Door pulses configured to 4 sec.)
ON 25 sec.
x The Hood Pin-switch has been pressed twice: the Unit went into step 1 of the
Programming Centre procedure, and no Transmitter activity was detected for
20 seconds.
x Or the Unit went into step 1 of the Transmitter programming procedure and
no activity was detected for a few seconds. The Unit has exited the
Transmitter programming procedure.
Irregular
x If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back Start Failure Codes.
This occurs when the Hood Pin-switch is pressed three times