Filter
Top Products
P. 18 Installation Guide AS-1725 SH
x Active Arming: the Starter Kill will not arm automatically. Press the LOCK button to
arm and the UNLOCK button to disarm it.
x Passive Arming: the Starter Kill will arm automatically if it is not armed by remote
within a 60-sec. delay. Press UNLOCK to disarm.
x Passive Arming with 3-minute timeout: the Starter Kill will arm automatically after
3 minutes.
Resetting the Remote Car Starter
The Remote Car Starter is equipped with a reset function that allows the installer to erase all
Transmitter codes from memory and return all the Programming Options to the factory
default values.
Resetting the Remote Car Starter is not a required process. Most of the time, you can avoid
resetting by fixing the issue directly at the root of the cause.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 10 seconds to complete the next step.
2. Press and release the Break Pedal 6 times (within 10 seconds from entering
Programming Mode).
3. The Parking Lights will flash 8 times to confirm resetting.
Table 8: Resetting without a Valet Button
On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if
the Brake Pedal is pressed while the Ignition Key is not in the IGNITION ON (RUN) position: you
will need therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test
lead at the Brake Pedal switch.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 10 seconds to complete the next step.
2. Press and release the Valet Button 6 times or more until the Parking Lights start to
flash.
3. The Parking Lights will flash 8 times to confirm resetting.
Table 9: Resetting with the Valet Button
Events Logging
With this feature, the Remote Car Starter will play back the last 4 Start Failure Events
Codes and the last Intrusion Code via the Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
OFF.
x Hold down the Hood Pin-switch for 4 seconds.
x Release the Pin-switch. The Parking Lights will come on.
x While the Parking Lights are on, immediately push the Pin-switch 3 more times
(down-up / down-up / down-up).
The Parking Lights and L.E.D. will flash the five events stored in memory.
Table 10: Events playback
The first four playback codes are Start Failure Events. There is a pause after each event
code is played back.
The system will play back the most recent event first, then the second one, and so on. If
there is no event at all to report, the Parking Lights will give one long flash.