Filter
Top Products
EXP
-
52
2
3. PANIC FUNCTION
The EXP-52 remote control may be used as a remote panic switch to
trigger the siren in cases of emergency. To activate the PANIC
FUNCTION press and hold the ON/OFF button on the remote transmitter
for a minimum of 3 seconds. The siren will sound. To stop the PANIC
FUNCTION press the ON/OFF button on the transmitter.
4. DELETING THE PRE-WARNING SENSOR CIRCUIT (If installed)
The EXP-52 offers the dual stage SIS-5 impact sensor to pre-warn a
light impact on the vehicle with a siren chirp before triggering the alarm.
The alarm will trigger with the third violation within 15 seconds. The
EXP-52 also provides a pre-warning sensor input for an additional
sensor like a radar sensor to pre-warn approach to the vehicle.
To delete the pre-warning sensor, press the ON/OFF button again within
5 seconds after arming. The siren will confirm deletion with a low chirp.
NOTE: Deleted sensor(s) will return to normal operation upon
disarming the EXP-52. Sensor(s) deletion procedure must be followed
each time the EXP-52 is armed. This operation deletes only the pre-
warning sensor of the alarm.
NOTE: This pre-warning feature is set inactive by the factory, and must
be activated at the time of installation if this feature is desired.
5. TRUNK/HATCH RELEASE
To remotely release the electric trunk or hatch on the vehicle you must
first disarm the EXP-52. After disarming, push the AUX button on the
transmitter for THREE (3) seconds. Trunk or hatch will release and
open. NOTE: The alarm will not control mechanical/latch trunk release
mechanisms.