Filter
Top Products
EXP
-
52
8
1. Flip the VALET/OVERRIDE switch to "ON" position.
2. Turn the ignition switch to "ON", then "OFF", then immediately
3. Flip the VALET/OVERRIDE switch "OFF", "ON/OFF", "ON/OFF". The
siren will chirp one (1) time.
4. Turn the ignition switch "ON/OFF", "ON/OFF". The siren will chirp two
(2) times. You are now in the programming mode.
5. Press the ON/OFF button on one of the remote transmitters until the
alarm siren responds with a confirming chirp. The first transmitter is
now programmed.
Within five (5) seconds, press the ON/OFF button on the second
transmitter until the alarm siren responds with a confirming chirp.
The second transmitter is now programmed.
NOTE: If the EXP-52 does not receive a second code to learn within
five (5) seconds, it will automatically close the programming mode
and resume normal alarm functions. If this happens, it will be
necessary to repeat steps 1 through 6 and re-program all
transmitters. If three or four transmitters are programmed, continue
pressing the ON/OFF button of the third and/or fourth transmitters.
6. The EXP-52 can learn up to four remote transmitter codes. If later
optional third and forth transmitters are to be programmed, follow
sequence 1 through 6 and re-program all existing transmitters.
K. PROGRAMMING REMOTE FOR A SECOND VEHICLE
The EXP-52 transmitters are capable of controlling separately installed
EXP-52 or RF-302 alarm systems in two or three vehicles.