Filter
Top Products
Delay Select.
Siren/Horn Chirp 7x, Light Flash 7x, LED Flashes 7x Pause, 7x Pause, indicating feature 7 selected. Use Factory Lock
button of transmitter or the factory door lock switch to select.
1 Chirp, 1 Flash = Door Trigger Instant
2 Chirp, 2 Flash = Door Trigger Delay
8. Press and release valet push-button switch 1x to advance to feature #8, one wire or two wire disarm select. Use
Factory Lock button of transmitter or the factory door lock switch to select.
1 Chirp, 1 Flash = 1 Wire Disarm
2 Chirp, 2 Flash = 2 Wire Disarm.
NOTE: The program mode is exited if any of the following occur:
a. 15 seconds of inactivity expire during any of the above steps.
b. The ignition key is turned off.
c. The push button switch is activated more than 8 times .
The Siren/Horn will emit a long chirp followed by a short chirp indicating the program mode has been exited.
MANUAL OVERRIDE
To Operate The Manual Override:
1. Enter the vehicle, the alarm will sound.
2. Turn the ignition switch on.
3. Within 10 seconds, begin to enter the tenths digit of the stored override code by pressing and releasing
the override push-button 1 through 9 times.
4. Within 10 seconds, turn the ignition switch off then on.
5. Within 10 seconds, begin to enter the units digit of the stored override code by pressing and releasing the
override push-button 1 through 9 times.
6. Within 10 seconds, turn the ignition switch off then on and start the vehicle.
When the ignition switch is turned off, in step # 6, if the correct code was entered, the siren will turn off and then emit two
chirps indicating successful disarm.
If the correct code is not entered, the siren will continue to sound, the parking lights will continue to flash, and the unit
will not disarm. The operator has 3 attempts to enter the proper disarm code. If the correct code is not entered the unit
will prevent disarming by use of the override switch for 10 minutes.
Note: If the transmitter is used during the 10 minute lockout mode, the system will disarm.
NOTE: The default override code, as shipped from the factory, is 11. For additional security, it is suggested
that the default override code be changed to a number more familiar to the operator.
To Program The Override Code:
1. Disarm the system by use of the factory transmitter or by use of the override push-button switch.
2. Turn the ignition switch on.
3. Within 10 seconds, press and release the override push-button 3x.
4. Within 10 seconds, turn the ignition switch off, on, off, on, off, on.
(Siren/Horn Chirps 1x and lights flash 1x.)
5. Within 10 seconds, begin to enter the tenths digits of your code, 1 through 9. Once the last digit is entered,
6. Within 10 seconds, turn the ignition switch off then on.
7. Within 10 seconds, begin to enter the units digit of your code. 1 through 9. Once the last digit is entered,
8. Turn the ignition off, or allow 15 seconds to expire to store and exit the program mode.
If the new code was successfully entered, the LED will flash the new code three times first indicating the tenths digit
and then the units digit.
To Enter The Valet Mode:
Disarm the unit by use of the factory transmitter or by use of the manual override sequence.
Turn the ignition switch to the “On” position.
Press and hold the pushbutton switch for 5 seconds. LED turns on, indicating valet mode successfully entered.
To Exit The Valet Mode:
With the ignition switch in the on position, press and release the pushbutton switch one time. LED turns off indicating
valet mode successfully exited.
Page 7