Filter
Top Products
-7-
system is in the armed mode, it will be necessary to override the system to
operate the vehicle. In this situation, to override and disarm the system:
Start with the valet/override switch in the off position. Open the vehicle door with
the door key. (The alarm will sound). Turn the ignition switch to the on position.
"Within 10 seconds" turn the valet/override switch to the on position.
The alarm will disarm and the vehicle can now be started and operated normally.
Always remember to move the valet/override switch to the off position to insure the
vehicle remains protected.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS:
You can selectively eliminate the normal arm and disarm chirps by holding the lock
or unlock button slightly longer when arming and disarming. This will prevent the
siren chirps for one arm or disarm cycle. If you wish to disable these chirps all the
time:
Start with the valet/override switch in the off position. Turn the ignition switch on,
then off. Within 10 seconds of turning off the ignition, flip the valet switch on, off, on,
off, on, then off.
If the chirps were enabled before you started, the siren will emit two short chirps
indicating that the chirps are now disabled. If the chirps were disabled before you
started, the siren will emit one short chirp indicating that the chirps are now en-
abled.
NOTE: If the chirps have been disabled, this effects only the normal one chirp
(arm/lock) and the two chirp (disarm/unlock) chirps. The three chirp defective zone
and the four chirp tamper indication remain operational. These chirps are for safety
and will not be disabled. If the vehicle battery is disconnected for servicing, when
power is restored, the arm/disarm chirps will revert to normal operation.
REMOTE PANIC OPERATION:
The panic feature can be operated from the maximum operating range of your
keychain transmitter. Access to the panic feature can be programmed to operate
from the transmitter button with the red lock symbol on it or can be operated from a
dedicated panic button as shown on page one of this manual. In either case,
dedicated panic button or operation from the lock button, press and hold this but-
ton for 3 seconds to activate the panic feature. Once activated, the siren will sound
and the parking lights will flash for a period of 30 seconds. If you wish to cancel the
panic mode anytime during the 30 second cycle, press and release the button
used to activate the feature.
REMOTE SHOCK SENSOR CONTROL:
The shock sensor feature of your security system is intended to detect strong vi-
brations or impact to the vehicle when attempted break-ins are made to the vehicle's
glass. The shock sensor is operational every time you lock/arm your security sys-
tem. It may be necessary at times to disable the shock sensor for one arming cycle