Filter
Top Products
will begin to flash rapidly indicating that the system is re-arming. Opening any
door will suspend the automatic arming cycle. If the parking lights flashed three
times, and the siren chirped four times, this indicates that the alarm system had
been triggered in your absence. Before turning on the ignition switch, examine
the dash mounted LED's flash pattern. The number of flashes identifies the
violated zone. For additional information, refer to the "Intrusion Warning Signals"
shown later in this manual. If upon disarm, the siren did not chirp two times, refer
to the section entitled "Eliminating The Arm/Disarm Chirps".
INTRUSION WARNING SIGNALS:
The system will warn you if an intrusion attempt has been made in your absence.
Upon disarm, the siren will chirp four times and the parking lights will flash three
times, indicating that the security system had been triggered. Enter the vehicle
and before turning on the ignition switch, observe the LED flash pattern.
If the LED is flashing 1x pause, 1x pause, etc... then an intrusion attempt was
made and detected by the shock sensor.
If the LED is flashing 2x pause, 2x pause, etc... then an intrusion attempt was
made and detected by opening of the hood or trunk.
If the LED is flashing 3x pause, 3x pause, etc... then an intrusion attempt was
made and detected by opening of the vehicle doors.
If the LED is flashing 4x pause, 4x pause, etc... then an intrusion attempt was
made and detected by any additional sensors connected to the vehicle.
All of the above LED patterns are intended to give you the opportunity to inspect
area's of your vehicle for possible damage. These LED warning patterns are stored
in the system's memory and will be erased when the ignition key is turned to the on
position.
VALET OPERATION:
The valet switch allows you to temporarily by-pass all alarm functions, eliminating
the need to hand your keychain transmitter to valets or garage mechanics. When
the system is in the valet mode, all alarm features are by-passed however, the
panic feature, as well as the optional door lock/unlock circuit, will remain opera-
tional. To enter the valet mode:
Start with the alarm disarmed and valet switch in the off position.
Turn the ignition switch to the on position.
Turn the valet switch to the on position.
The dash mounted LED will turn on solid indicating that the valet mode has been
successfully entered.
To return to the normal mode of operation, move the valet switch to the off position
any time the ignition switch is in the on position.
MANUAL OVERRIDE OPERATION:
In the event you lose your transmitter or if the transmitter battery fails while the
-6-