Filter
Top Products
50 times away from the alarm system, it is possible for the unit to go out of syn-
chronization. If this occurs, simply pressing the transmitter button 2 times within 1
second will realign your transmitter to the alarm. Once realigned, normal opera-
tion is resumed.
ARMING THE SYSTEM, Active:
Turn the engine off, exit the vehicle and close all doors, hood, and trunk.
Press and release the transmitter button with the lock icon on it.
The parking lights will flash once, the siren will chirp once, and the dash mounted
LED will begin to flash slowly indicating that the system is armed. If you have the
optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren chirped three times, this indicates that a door, hood or trunk has
been left ajar. Simply closing that open entry point will provide full protection. If the
siren did not chirp upon arming of the system, then the chirps have been turned
off. Refer to the section entitled "Eliminating the Arm/Disarm Chirps" shown later
in this manual.
SILENT ARMING, Active:
Turn the engine off, exit the vehicle and close all doors, hood, and trunk.
Press and hold the transmitter button with the lock icon on it for 2 seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash
slowly indicating that the system is armed. The siren will not chirp. If you have the
optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren chirped three times, this indicates that a door, hood or trunk has
been left ajar. Simply closing that open entry point will provide full protection.
ARMING THE SYSTEM, Passive (Automatic):
If the passive (automatic) arming feature has been selected:
Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second
passive arming cycle has begun. If the LED does not begin to flash rapidly, a door,
hood or trunk has been left ajar. Simply closing that open entry point will allow the
arming cycle to begin. Any entry point opened during the 30 second arming cycle
will suspend the arm timer. When all entry points are closed, the arm timer will
begin again.
At the end of the 30 second arming cycle, the parking lights will flash once, the
siren will chirp once, and the dash mounted LED will begin to flash slowly indicat-
ing that the system is fully armed. If the siren did not chirp upon completion of the
arming cycle, the chirps have been turned off. Refer to the section on "Eliminating
the Arm/Disarm Chirps" shown later in this manual. Passive door locking is a
selectable feature. If you have the optional door lock/unlock circuit installed, the
doors may or may not lock dependent on the setting of this selectable feature at
time of installation.
-4-