Filter
Top Products
LOCK: The closed lock symbol is the Lock and Arm button of your
transmitter. This function will allow the locking of the vehicle doors
(with optional door lock interface and power door locks), and the
arming or setting of the security system.
UNLOCK: The open lock symbol is the Unlock and Disarm button
of your transmitter. This function will allow unlocking of the vehicle's
driver door, or all doors, (with optional door lock interface and power
door locks), dependent on the way the control module is pro-
grammed. This button will also disarm the security system if it is
armed.
TRUNK: The open trunk symbol on the transmitter button will oper-
ate the vehicle's trunk release, (option, with existing power trunk,
relay required). Press and hold this button for two seconds to acti-
vate the trunk release option.
HEADLIGHT: The headlamp symbol on the transmitter button will
allow you to turn on the headlamps (with optional relay), at any time
to illuminate your path to and from your vehicle. Pressing this but-
ton will turn on the headlamps from the maximum operating dis-
tance of the transmitter. The lights will remain on for 20 seconds
then will automatically turn off.
START: The key symbol on the transmitter button will activate the
optional remote control starting device if added to your vehicle. This
button will always require a double push to active the remote start
unit. This is to prevent accidental, unintended, activation of the
remote starting device. To remote start your vehicle, press this but-
ton two times within 5 seconds.
PANIC: This Red circular symbol on the transmitter button will acti-
vate the security system's panic feature. This allows the operator to
turn on the siren and flash the parking lights from the maximum
operating range of the transmitter. To activate the Panic feature,
press and hold this button for three seconds. To turn off the panic
mode, press and release the same button one time. If you do not
turn off the panic mode, the siren will sound and the lights will con-
tinue to flash for 30 seconds.
NOTE: If there is no separate panic button as shown on your trans-
mitter, then the red lock symbol button is used for panic. Operation
is the same as described above.
TRANSMITTER ICONS (Symbols):
The PRO-9744's 4 button transmitter has a replaceable membrane (button pad)
that uses icons to denote operation of your security system. The icons used are a
standard in use by the automotive industry. Their functions are described below.
-2-