Filter
Top Products
Brake Switch Positive Shutdown Detail
YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass Output
NOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE ALARM FROM ANY OTHER WIRE
THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.
This wire providesa+12Volt output when the ignition key is turned to the “ON” position, and 0 Volts when
the ignition key is “OFF” and when the vehicle is running under the control of the remote starter.
This wire should be connected to the ignition input of the alarm system.
The Yellow w/ Black wireoutput will allow you to remote start the vehicle while leaving the alarm armed, and
to lock/unlock the doors while running under control of the remote start unit.
(2) WHITE Wires: Parking Light Flasher
These wires are the COMMON and NORMALLY OPEN contacts of the on-board parking lamp relay.
If the vehicle's parking lights are a +12 volt switched system, connect (1) of the White wires to a fused
(15A max.) +12 volt battery source, and connect the second White wire to the vehicle's parking light wire.
Ifthevehicle'sparking lightsareachassisgroundswitched system,connect(1)oftheWhitewires toachassis
ground source, and connect the second White wire to the vehicle's parking light wire.
6
Whiteor Whitew/Red
TraceWireFromRemote
StartModule
WhiteFromRemote
StartModule