Filter
Top Products
128-6995
17 of 20
ADDITIONAL REMOTE FEATURES:
The two way remote control unit allows you to access status information from
the vehicle, check temperature, light the display, toggle
the transmitter from beep tones to vibrate mode, initiate
daily start timer, and temperature start. Selection of
these and other features are shown below:
NOTE: Transmitter must be within operating range of
the vehicle, approximately 1000 ft.
Check Vehicle Status:
Press the lock+key+option buttons simultaneously for 1 second. The vehicle's
alarm will display the systems current status.
Check Temperature:
Press the option+key buttons simultaneously for 1 second. The vehicle's alarm
will display the temperature. Temperature is read from the alarm's module
located below the dashboard. This reading may be higher than actual ambient
temperature due to the greenhouse and is relative only to the inside vehicle
temperature.
Temperature Start Mode:
To toggle this feature on or off, from the armed mode, press the Option & Unlock
Buttons simultaneously, the temperature icon appear on, or disappear from the
display, and the transmitter will emit a tone.
NOTE: This feature must be active in the feature selection menu of your system.
Check with your installing dealer to insure this feature is set to the on position.
Light The Display:
Press and release the "F" (Function) button one time. The display will illumi-
nate for 10 seconds.
Vibrate Or Tones:
Press the "F"+Unlock buttons simultaneously for 1 second. The transmitter will
vibrate if vibrate is on or beep if tones are turned on. Pressing this button
combination again will toggle this feature on or off.
Daily Start Timer:
Press the option+lock buttons simultaneously for 1 second. The transmitter will
beep and display the 24hr timer. The vehicle will start automatically when the
time set is reached. (see chart for time settings). Pressing this button combina-
tion a second time will toggle this feature off. Note the transmitter must be
within range of the vehicle to set this feature and within range to cause the
vehicle to start at the preset time. The unit will start at the prescribed time once
only. This function must be selected each time you want the vehicle to start. To
activate this function, (a) Turn the ignition switch off. (b) Within 10 seconds of
step (a), depress and hold the brake pedal, while pressing the key icon
transmitter button 2 times. (c) the unit will emit 2 chirps, the transmitter will beep
and the start timer icon on the display will remain on.
Note this feature must be pre-selected at time of installation and will require
resetting each day. Also the unit will start once and run for the prescribed time.