Filter
Top Products
128-6995
16 of 20
icons shown left will appear on the screen.
If the alarm system has been triggered, the icon dis-
played on the transmitter LCD will indicate the which
zone has been activated, as well sound the beep tones,
or vibrate dependent upon the setting as shown above.
The following trigger patterns will be displayed.
Triggered and the entry attempt was made to one of
the vehicle doors.
Triggered and entry attempt was made to the vehicles
hood or trunk.
Triggered and entry attempt was made to the vehicles
glass, or the vehicle has been hit or bumped hard
enough to cause a response from the vibration detec-
tor.
ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:
If the arm/disarm chirp tones have been turned off at
the vehicle, when you arm, or disarm, the display will
indicate this as shown and there will be no arm/dis-
arm chirps at the transmitter. This is true if the trans-
mitter is set for vibrate mode.
When the vehicle is armed, and a door is opened, or
ajar, the transmitter will chirp 3 times, the lights will
flash, and then the display will flash as shown. When
the door is closed or the zone clears, the transmitter
will chirp 1 time, and the display will clear.
When the vehicle is armed, and the hood or trunk, is
opened or ajar, the transmitter will chirp 3 times, the
lights will flash, and then the display will flash as
shown. When the hood or trunk is closed, or the zone
clears, the transmitter will chirp 1 time, and the dis-
play will clear.
When the vehicle is armed, and the vibration sensor
input is active, the transmitter will chirp 3 times, the
lights will flash, and then the display will flash as shown.
When the input or the zone clears, the transmitter will
chirp 1 time, and the display will clear.