Filter
Top Products
128-8604
5 of 8
2. Turn the ignition switch to the on position.
3. Within 10 seconds, press and release the push-button switch found on the receiver
assembly 3 times.
4. Within 10 seconds turn the ignition switch off, on, off, on, off, on.
(The siren or horn will beep and the lights will flash one time.)
5. Within 10 seconds, begin to press and release the push-button switch to set the tenths
digit.
(As per the example, press and release 5 times to set the tenths digit to 5)
6. Within 10 seconds of the last press of the push-button, turn the ignition switch
off then on.
7. Within 10 seconds, begin to press and release the push-button switch to set the units
digit.
(As per the example, press and release 2 times to set the units digit to 2).
8. Turn the ignition switch to the off position. Immediately observe the LED
flash pattern.
You will note the LED flashing five times, pause, and then flash two times, pause. This
pattern will be repeated three times indicating the new code (52) has been accepted and
stored in memory.
NOTE: If after step 7, the LED flashes a code other than what was just entered,
this indicates that the code has not been changed. You will have to repeat
steps 1 through 7 above being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recog-
nize a 0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for
more then 5 seconds during any of the above steps, the unit will revert back
to the last successfully stored code.
OPTIONAL IGNITION LOCK/UNLOCK FEATURE :
If your existing factory installed keyless entry system did not include an ignition on/off door
lock and unlock feature, this feature can be activated from this upgrade system. When this
accessory has been added, any time the ignition key is turned to the on position and all vehicle
doors are closed, the doors will lock in 4 seconds. Additionally, any time the ignition key is
turned to the off position, the doors will unlock.
ELIMINATING THE ARM / DISARM CHIRPS :
The normal arming and disarming confirmation chirps can easily be turned off using the valet
pushbutton switch found on the glass mounted receiver assembly. To do this;
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the push-button
valet/override switch 3 times.
3. a. If, before proceeding with step 1, the chirps were on, then you will hear 2
chirps to indicate that the chirps have been turned off.
b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
4. Whenever power to the system has been disconnected ( for repair or service
to the vehicle ), the chirps will be activated when the power is re - connected.
To turn the chirps off, simply execute steps 1 through 3 above.
NOTE : Whenever the Arm/Disarm chirps are bypassed, the 3 chirp defective
zone and the 4 chirp intrusion indicator will continue to operate. This
feature will always warn you if a door was left ajar when arming, or the
vehicle was tampered with in your absence.
REMOTE STARTING THE VEHICLE
The System WILL NOT start the vehicle if any one of the following conditions exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The glass mounted push-button safety control Is In The Remote Start By-Pass mode.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
Page 5