Filter
Top Products
128-6199
2 of 8
Page 2
or
Eighth Press and release the valet switch 1 chirp = siren and horn output
Press transmitter Lock button to change 2 chirps = siren output only
Press transmitter lock button to change 3 chirps = horn output only
or
Ninth Press and release the valet switch 2 chirps = horn chirp output 16mS
Press transmitter Lock button to change 3 chirps = horn chirp output 30mS
Press transmitter Lock button to change 1 chirp = horn chirp output 10 mS
or
Tenth Press and release the valet switch 2 chirps = valet switch override operation
Press transmitter Lock button to change 1 chirp = custom code override operation
or
Eleventh Press and release the valet switch 2 chirps = 2 step unlock off
Press transmitter Lock button to change 1 chirp = 2 step unlock on
or
Twelfth Press and release the valet switch 2 chirps = chirp delete from transmitter inactive
Press transmitter Lock button to change 1 chirp = chirp delete from transmitter active
Press and release the valet switch Exit program mode
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
INSTALLATION OF MAJOR COMPONENTS
Control Module :
Select a mounting location inside the passenger compartment ( up behind the dash ) and secure using the two screws provided. The
control module can also be secured in place using cable ties.
Do not
mount the control module in the engine compartment, as it is not waterproof. You should also avoid mounting the unit
directly onto factory installed electronic components. These components may cause RF interference, which can result in poor
transmitter range or intermittent operation.
Siren :
Select a mounting location in the engine compartment that is well protected from access below the vehicle. Avoid areas near
high heat components or moving parts within the engine compartment. To prevent water retention, the flared end of the siren
must be pointed downward when mounted. Mount the siren to the selected location using the screws and bracket provided.
Hood or Trunk Pin Switch :
A pin switch is included for use in protecting the hood or trunk ( or hatchback ) of the vehicle. The switch must always be
mounted to a grounded, metal surface of the vehicle. It is important to select a location where water cannot flow or collect, and
to avoid all drip gutters on hood and trunk fender walls. Choose locations that are protected by rubber gaskets when the hood
or trunk lid is closed.
The pin switch can be mounted using the bracket provided, or direct mounted by drilling a ¼ " diameter mounting hole. Keep in mind
that when properly mounted, the plunger of the pin switch should depress at least ¼ " when the hood or trunk lid is closed.
Dash Mounted LED :
A small LED is included that will serve as a visual indicator of the alarm status. It should be installed in the dash, located where
it can be easily seen from outside the vehicle, yet not be distracting to the driver.
Once a location has been selected, check behind the panel for wire routing access, and to confirm the drill will not damage any
existing components as it passes through the panel.
Drill a ¼ " diameter hole, and pass the red and blue wires from the LED through the hole, from the front of the panel. Firmly press the
body of the LED into the hole until fully seated.
Valet Switch :
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch does not have to be
concealed, however, concealing the switch is always recommended, as this provides an even higher level of security to the
vehicle.