4
THE REMOTE CONTROL
Your remote control works off two small 3 volts lithium batteries ( CR2016).
When replacing the batteries, make sure to place the new batteries in the up right position
(see the illustration), also make sure to put the small isolating strip back.
See your dealer for replacement batteries or additional remote controls.
The range of your remote control can be affected by a weak battery, interference from
nearby metal structures, hydro poles, or crowded parking lots.
With its electronic CODE LEARNING feature, up to four remote controls can be programmed for your vehicle.
USING YOUR REMOTE CONTROL
To ensure that commands are transmitted properly, press desired button for 2 seconds. A command will not be executed if
you do not press button long enough.
Indicator light will flash while transmitting the command.
Remote(s) included in kit may differ from the ones illustrated.
TABLE OF COMMANDS
BUTTONS CONFIRMATION
COMMANDS
RS-611
RS-613
RS-711XR
LIGHTS HORN
START / STOP (TOGGLE)
1 / 1 -
STOP (BUTTON HELD IN > 4 SEC.)
1 -
START
1
/ 1 1
LOW TEMPERATURE MODE
1
/ 2 / 3 / 4
-
PANIC (BUTTON HELD IN > 4 SEC.)
OU
30
/ 60 SEC.
TRUNK / ACCESSORY
3 -
UNLOCK
2 -
LOCK
1 1
THIS CONFIRMATION IS SENT ONLY WHEN COMMAND IS REPEATED WHILE ENGINE IS ALREADY RUNNING.
1 = DEACTIVATION OR SYSTEM NOT READY / 2 = ACTIVATION 4 MIN. / 3 = ACTIVATION 8 MIN. / 4 = ACTIVATION 18 MIN. –
DURATIONS ARE DOUBLED IN DIESEL MODE.
PROGRAMMABLE DURING INSTALLATION – 2
ND
LOCK