Filter
Top Products
INSTALL MANUAL REMOTE VEHICLE SECURITY
PAGE 8
Enter Program Mode
Entering program mode is done by the following steps:
1) Make sure ignition is in the off position.
2) Turn the ignition key ON - OFF, leaving key in the OFF position.
3) Press and release the Valet button two times.
4) The siren will chirp one time to confirm entering program mode.
( If this does not happen, turn ignition off, wait five seconds and repeat steps 1-4).
Shock Sensor Disable
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence:
#3 - #3 then #1
3 - The siren will respond with the following:
1 Chirp Shock Sensor OFF
2 Chirps Shock Sensor ON
Arm/ Disarm Chirp
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#2 - #1 then #1
3 - The siren will respond with the following:
1 Chirp Chirps Disabled
2 Chirps Chirps Enabled
Ignition Auto Locks
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #3 then #2.
3 - The siren will respond with the following:
1 Chirp Auto Lock Disabled
2 Chirps Auto Lock Enabled
Door Lock Timing
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #3 then #1
3 - The siren will respond with the following:
1 Chirp 3 Second Door Locks
2 Chirps 0.75sec Pulses
Double Pulse Unlock
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#2 - #2 then #1.
3 - The siren will respond with the following:
1 Chirp Double Pulse Unlock
2 Chirps Single Pulse Unlock
NOTE: Repeat sequence to change selection