Ultra Start CJ series Automobile Alarm User Manual


 
REMOTE VEHICLE SECURITY INSTALL MANUAL
PAGE 5
Recommended Installation Procedures
White (+) Park lights Park light output.
Orange* (-) When Armed Negative output when system is armed.
Grey* (-) Trunk Release Negative output for trunk release.
Yellow (+) Ignition Input Input from vehicles ignition wire.
Red (+) 12Volt Input Constant 12 Volt input.
Brown (+) Siren Output Positive output for siren.
Black (-) Ground Input System ground input.
Purple (+) Door Input Positive door pin switch input.
Green (-) Door Input Negative door pin switch input.
Blue (-) Hood Input Negative input from hood pin switch.
Blk/White* (-) Dome Supervision 30 second (-) output when disarmed.*
*This wire is only available on models with the 11 pin connector.
10 Pin / *11 Pin Connector
Green* (-) Door Lock Door Lock Output (Programmable)
Red* (+) 12 Volt Output 12Volt Output for voltage inverter.
Blue* (-) Door Unlock Door Unlock Output (Programmable)
*NOTE: 500ma outputs ONLY!
3 Pin Connector Red
Under Hood Connections- Route the hood pin (optional) and Siren wire
through the firewall, into the engine compartment. Always try to pull the wires
through a factory rubber grommet. If drilling through the firewall, BE CAREFUL.
Check for obstructions on both sides of the firewall. After drilling use a snap in
grommet to protect the wires from sharp edges.
Mounting the module-Never mount the module in the engine compartment.
Select a location under the dash to install the main module. Be certain that the
module is securely attached and does not obstruct any serviceable areas.
Mount the module so that it cannot be seen if looking under the dash as it could
be easily unplugged by a thief. The module must be free from all moving parts.
Mounting the Siren- Choose a location in the engine compartment that is
away from high heat sources and direct exposer to water. The siren should be
mounted as well as grounded to solid metal. Run the wiring for the siren so that
it can not be seen or reached from below the vehicle.
Wiring Descriptions