Filter
Top Products
REMOTE VEHICLE SECURITY INSTALL MANUAL
PAGE 7
Changing A Programmable Setting
Quick View Programming
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON the OFF.
3) Press and release the Program Button two times.
4) The siren will chirp and the lights will flash once to confirm.
NOTE: If unit does not enter Program Mode, repeat steps 2-3.
** The ignition input wire(yellow on the 10 pin connector) MUST be connected.
If it is not connected it will not be possible to enter the Program Mode.
1) Enter Program Mode As explained above.
2) When in program Mode, change the desired Program Setting by pressing
the transmitter buttons in the following sequences.
NOTE: The Systems Default Setting Are Shown In Bold Lettering.
Programmable Feature Press Buttons One Chirp Two Chirps
Shock Sensor Disable #3-#3-#1 Disabled Enabled
Arm / Disarm Chirps #2-#1-#1 Chirps Off Chirps On
Ignition Auto Locks #1-#3-#2 Off On
Door Lock Timing #1-#3-#1 3 Second .75 Second
Double Pulse Unlock #2-#2-#1 Two Pulses Single Pulses
Door Input / Voltage Sense #1-#1-#3 Voltage Door Pin
Passive / Active Locks #3-#3-#2 Active Passive
Passive / Active Arming #1-#2-#3 Active Passive
Car Jack Mode* #2-#1-#3 Deactivated Activated
Siren/ Horn Output** #3-#2-#1 Siren Horn
System Reset #3-#3-#3 Confirmed by Three Siren Chirps
*CJ series ONLY
**441 series ONLY
Programming
#1#1 #2#2
#3#3
#1#1 #2#2
#3#3