Filter
Top Products
- Press and release to arm the alarm and lock the doors.
- Press and hold to activate Panic mode.
- Press and release to deactivate triggered alarm.
- Press and release to disarm and unlock the doors.
- Press and hold to activate the Trunk Release.
- Press and release to deactivate triggered alarm.
- Press and hold to activate the Car Finder Mode.
Button #1
Button #2
Button #3
Transmitter Programming
Deleting Transmitters
Follow the steps below to program the transmitters to the system s memory
Step 1 - Turn the Ignition key ON then OFF - Leaving Key Off.
Step 2 - Press and release the Program Button twice then press and hold.
Step 3 - The siren will respond with five chirps to confirm Transmitter Program Mode.
Note: If the siren does not respond, repeat Steps1&2
Step 4 - Continue to hold the Program Button and press lock button on each of the
transmitter’s to be programmed(Maximum of 3 Different transmitter codes).
Step 5 - The system will respond with a siren chirp each time a transmitter is programmed.
Exit - After five seconds the system will exit transmitter program mode automatically.
NOTE: You must program ALL of the transmitters to be used at one time. For the owner’s
security any transmitters not programmed at this time will be erased from memory.
*** This system will store a maximum of three transmitter codes in memory.
Follow the steps below to permanently delete a transmitter code from the system s memory.
Step 1 - Turn the Ignition key ON then OFF - Leaving Key Off.
Step 2 - Press and release the Program Button twice then press and hold.
Step 3 - The siren will respond with five chirps to confirm Transmitter Program Mode.
Note: If the siren does not respond, repeat Steps1&2
Step 4 - Continue to hold the Program Button and press lock button on only the transmitters
that are intended for use on the system.(*Maximum of 3 Different transmitter codes).
Step 5 - The system will respond with a siren chirp each time a transmitter is programmed.
Exit - After five seconds the system will exit transmitter program mode automatically.
All previous transmitter code are now deleted from the systems memory.
#1 #2
#3
#1 #2
#3
#3
Basic Transmitter Functions