Filter
Top Products
Starter Disable
The system has an optional starter disable output that can be connected by your
dealer. When the starter disable relay is installed and connected to the system,
the vehicle’s starter will be disabled when the system is armed.
To activate the starter disable press the lock button on the remote. The system
will arm and the starter will no longer operate.
To deactivate the starter disable, press the unlock button and the LEDS will stop
flashing and the starter will be re-enabled.
Emergency Service Mode temporarily disables the alarm system. This feature
can be used if the remote is lost or if the system malfunctions.
ENTERING VALET MODE
1.While the ignition is “On” press and hold the Service button for five seconds.
The siren will chirps five times.
2.Alarm functions will be disabled and the LED will be ON steady. The door-locks
and trunk release are still operational.
EXITING VALET MODE
1.While the ignition is “On”press and hold the Service button for five seconds.
The siren will chirps two times.
2. The system returns to normal operation.
1. The system must be disarmed and the ignition is turned OFF.
2.Press and release the lock and unlock buttons at the same time, then press
and hold the lock button for five seconds.
3.The system will respond with five chirps and park light flashes to confirm
that the system is in Valet mode.
4. The LED will stay ON steady to confirm Valet Mode.
1.Press and release the lock and unlock buttons at the same time, then press
and hold the lock button for five seconds.
2.The system will respond with two chirps and park light flashes to confirm that
the system has exited Valet mode.
3. The LED will turn OFF.
Note: If the LED does not turn off, check that all the door’s are closed. The LED
stays On solid when a door is left opened.
Service Mode
Exit Service Mode
Emergency Service Mode