Ultra Start 25XX Series Remote Starter User Manual


 
Cold Start/Timer Mode will start the vehicle at a user selectable start
interval or temperature setting. The vehicle can be set to start once every
1, 2, 3 or 4 hours in Timer Mode or 0,-5,-15 or -25 Celsius in Temperature
Mode (LT Models Only) for a maximum 12 starts.
The vehicle will start at the selected start interval/temperature and run for the
programmed runtime(default 15min). Cold Start/Timer Mode must be set
each time the user wishes to use the feature.
Example- Timer Mode. If the 4 hour start cycle was selected, the vehicle
will start once every 4 hours and run for the programmed runtime.*
Example- Temperature Mode (LT models only). If the -15 Celsius start
cycle was selected, the system will monitor the temperature
(every 2 hours) until it falls below -15. The remote starter will start
and run for the programmed runtime.*
*(Default 15 min)
To Enter Cold Start/Timer Mode.
Press and release the # button, then press and hold the button for 6
seconds or until park lights turn on.
While the park lights are on the start cycle can be selected.
1 hour or 0C Press LOCK button 1 Park light flash
2 hour or -5C Press UNLOCK button 2 Park light flashes
3 hour or -15C Press START button 3 Park light flashes
4 hour or -25C Press # button 4 Park light flashes
Note: The optional Low Temp sensor must be installed for the temperature
settings to be available. (LT Models only)
To Cancel Cold Start/Timer Mode
Press and release the # button, then press and hold the START
button for 6 seconds.
Note: Pressing the brake pedal or turning the ignition to the ON position will
cancel Cold Start/Timer Mode. Cancellation will be confirmed with 2
park light flashes and 2 siren chirps.
*****Never remote start or set the Cold Start Mode if the vehicle is
parked in a Garage or Attached Carport!******
Cold Start/Timer Mode
Page 8
OWNER’S GUIDE REMOTE VEHICLE STARTER