Filter
Top Products
REMOTE VEHICLE STARTER
OWNER ’S GUIDE
Page 3
Remote Starting
Remote Star ter Functions
1.Press and release the button.
2.The park lights will flash and the siren will chirp one time.
3.The vehicle will then remote start. The park lights will flash four times
then remain on while the vehicle is running.*
Note: If the remote starter fails to start, the park lights will flash a Trouble
Shooting Code. Count the number of flashes and refer to the
Diagnostics Chart on page 10.
Never remote start if the vehicle is parked in a garage or attached
carport! Operate in a well ventilated area only.
Remote Stop
1.Press and hold the button for three seconds. The remote starter will
shut down. The park lights will flash and the siren will chirp 2
times to confirm shutdown.
Note: Pressing the brake pedal or opening the hood will also shut down
the remote starter.
Idle Mode
1. While the vehicle is running with key, press the button.
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key off and the vehicle will continue to run for the
programmed run time.*
Extended Run Time
Turbo Timer Mode
1.While the vehicle is running with key, press the # button.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key off and the vehicle will continue to run for
approximately 2 minutes.
*(Default 15 minutes)
1. Press and release the button while the vehicle is running.
2. The system will respond with one park light flash and siren chirp
to confirm Extended Runtime. The system will reset the run time*