Filter
Top Products
G
G - 9
ELECTRICAL SYSTEM
SATELLITE ANTENNA WIRING
If you compare the two previous drawings you’ll see wiring for a satellite dish
antenna is relatively simple.
Units have a faceplate with two coax cable hook-ups. It is located in the TV
credenza on all models except the slide-out model with the overhead TV,
which is located in the cabinet to the roadside of the TV. The faceplate has
a small coax cable jumper running between the hook-ups to complete the
cable TV circuit when in use. To install a satellite system use the following
procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the Cable TV receptacle in the roadside rear
underbelly compartment. This feeds the dish signal to the input side of the
faceplate.
3. Install the satellite receiver input and output into the dual coax faceplate.
To return to a cable TV system, remove the satellite receiver from the face-
plate and reinstall the jumper cable.
COAXIAL CABLE WITH CABLE HOOK UP
CO
AXIAL CABLE WITH SATELLITE HOOK UP
Exterior Cable TV Hook Up
Exterior Cable TV Hook Up
Dual Coax
Faceplat
e
Dual Coax
Faceplat
e
Jumper
Cabl
e
TV
TV
TV
TV
Satellite Antenna
Front TV Jack
W/Booster
Fr
ont TV Jack
W/Booste
r
Satellite
Reciev
er
TV Antenna
TV Antenn
a
Antenna Lead in
Antenna L
ead in