Filter
Top Products
E
E - 2
INTERIOR
Draperies
NOTICE: All drapery materials and mattress covers must be professionally dry-
cleaned.
For Safari models remove the draperies by unsnapping them from the wall, removing
a screw or pop rivet from the end of the curtain track, and sliding them out. The pop
rivets are removed by drilling through the head with a 1/8” drill bit.
Carpet
The carpet can be cleaned with any good commercial carpet cleaner, or with a deter-
gent and water. BE CAREFUL NOT TO SOAK THE CARPET WITH WATER.
Counter Area
The counter areas around the sink are of a high-pressure laminate and can be cleaned
with soap and water, or you can use a common solvent on tough spots. Be sure no
abrasive cleaner is used, as there is the possibility it could scratch the surface. A
protective pad should always be placed under hot utensils.
Vinyl Covering
Damp wiping with mild detergent does routine cleaning. Using any of the automotive
cleaners designed for vinyl car seats and dashes can perform a more thorough clean-
ing.
Sinks
Cleaning can be accomplished using mild liquid detergent with a soft cloth. A complete
Home Owners Guide for your sinks is supplied in your Owner’s Folder. Please read
these instructions before use.
Shower Stall
To clean your fiberglass shower stall unit use warm water and one of the stronger liquid
detergents. Do not use abrasive cleaners, they may scratch and dull the surface of your
unit. Stubborn stains can be removed with solvents such as turpentine, paint thinner or
acetone. Restore dulled areas by rubbing with an automotive type liquid cleaner then
put the soft slow back into your unit with a light application of liquid wax.
Lounges
On certain models the sofa converts to a bed,. Lift up the front of the seat and pull out.
Below the bed is a large upholstered, horizontal door that is opened by pulling straight
out and hinging down. This exposes large plastic trays. This is a great place to store
heavy items since it is low to the floor and in front the trailer.
WARNING: To prevent possible injury, these legs must be lowered and
locked into place after the top is pulled out and before putting weight on the bed.
Dinette
The dinette is made into a bed by rising up on the front of the table and folding the
table leg up against the bottom of the leaf. As the table is raised it will unhook from the
upper wall brackets. Once it is unhooked it can be pulled out and the wall hinge will
let it be lowered on the supports of the dinette seats. The backrests of the seats are
placed over the table to complete the conversion.
BUNK BED
The bunk bed is rated at 150 lbs. Do not overload the bed.