Filter
Top Products
B
B - 2
TOWING YOUR AIRSTREAM
ELECTRIC BRAKES
The brakes are operated by 12 volt current from your tow vehicle and MUST BE
HOOKED UP SO THAT YOU HAVE AN INTEGRAL SYSTEM WITH YOUR TOW
VEHICLE BRAKES. To prevent problems and insure satisfactory braking action, install
an electronic controller in line with the brakes in your tow vehicle.
An electronic controller installed in your tow vehicle will synchronize the trailer brakes
with your tow vehicle brakes. It is designed to apply the trailer brakes with your tow
vehicle brakes.
Your brake controller should be adjusted to provide for a slight lead of the trailer brakes
over the tow vehicle brakes. Follow the directions provided with your controller and
keep the information for future reference. Don’t be afraid to ask questions! If you don’t
understand the directions, have the installer explain the procedures.
Due to normal brake lining wear, the brakes and the controller setting should be
checked and readjusted, if necessary, during the trailer manufacturer’s recommended
inspection intervals.
NOTICE: Brake lining adjustment should be periodically checked (fully) to be sure
trailer brakes are in the same adjustment as the tow vehicles.
Properly set adjustments will provide for safe comfortable stops. They will also help
assure optimum brake and tire life for both the tow vehicle and the trailer.
In THE EVENT OF AN ACCIDENTAL SEPARATION of the tow vehicle and the trailer,
the BREAK-AWAY SWITCH will set and lock the trailer brakes for a sufficient length
of time to stop the trailer. The switch is activated when the wire attached to it and to
the tow vehicle pulls out the small pin in the front of the unit. THIS PIN SHOULD BE
PULLED OUT, LUBRICATED WITH LIGHT HOUSEHOLD OIL, AND REPLACED EVERY
90 DAYS.
To prevent corrosion within the breakaway switch, pull the switch’s pin straight forward
and spray the inside of the switch through the hole with an electric contact cleaner
(such as Spra- Kleen) and reinsert pin. A drop of light household oil on the groove
near the base of the pin will allow the pin to operate freely. WHEN THE TRAILER IS
CONNECTED TO THE TOW VEHICLE, THE BREAKAWAY SWITCH LOOP SHOULD
BE ATTACHED TO THE PERMANENT FRAME OF YOUR HITCH. When disconnecting
the trailer from the tow vehicle remove wire loop from the frame. DO NOT REMOVE
THE PIN FROM THE SWITCH BECAUSE THIS WILL APPLY THE TRAILER BRAKES.
NOTICE: Do not use breakaway switch for parking brake.