A SERVICE OF

logo

Open as PDF
next previous
Technical Information
6-96-9
4. Place one taped edge of target window [2] on indent [4] at
bottom of shoe [1].
5. Align hole of target window [2] exactly in center of hole in
sensor nose [3] and press remaining three sides of target
window into place.
6. Unlock shoe.
LAMP REPLACEMENT
Lamp Removal
1. Remove Optics assembly by removing sensor nose screws [1]
from the densitometer housing, and then lifting assembly
upward. THE THREE INNER SCREWS ON SENSOR NOSE
ARE NOT TO BE REMOVED. (Figure 5-5)
Figure 5-5
2. Once Optics assembly is free, rotate over and remove two
screws [4] from the lamp PCB [3]. (Figure 5-6)
Densitometer
Housing
1