X-Rite 400 Manual

A SERVICE OF

next previous

400 B/W Reflection Densitometer

1-61-6

BATTERIES AND POWER

Your 400 instrument’s batteries should be charged before use. It can

be operated while the batteries are being charged.

Before you begin charging, you must remove the battery isolation

insert protruding from the battery cover. (Figure 1-3)

Figure 1-3

NOTE: Make sure the voltage indicated on the AC adapter complies

with the AC line voltage in your area. If it does not, contact your

X-Rite dealer.

To charge the battery:

1. Plug the AC Adapter Line Cord into the AC Adapter Jack on

back of instrument. (Figure 1-4)

2. Plug AC Adapter into AC wall outlet.

You can use the instrument while it recharges. The instrument

will be fully charged in approximately 14 hours.

Figure 1-4

Battery Isolation Tab

Plug AC Adapter Cord

into AC

Adapter Jack