38 GL-1010 Administrator’s Guide
M If DHCP is selected, select MANUAL (make sure the IP
address and Default Gateway are all blanks or zeros)
M If MANUAL is selected, set the static IP address and
Default Gateway to all zeros or blanks
3 Reboot the controller.
4 Configure the wired networking on the controller via the
ADMIN>NETWORK SETTING button on the front panel.
n Select NETBEUI and select ENABLE (press NO if asked to
reboot)
n Select IPX/SPX and select ENABLE (press NO if asked to
reboot)
n Select APPLETALK and select ENABLE (press NO when asked to
reboot)
n Enable TCP/IP
M For DHCP or a fixed IP address, set a valid static IP
address, Subnet Mask, Default Gateway, DNS and WINS
servers accordingly and reboot the controller. If DHCP is
desired, press DHCP via the
ADMIN>NETWORK SET-
TING>DHCP button on the front panel and reboot the con-
troller
5 Perform a test print.
Switching back to wireless networking (the wireless
card is already installed)
1 Remove the network cable from the controller.
2 Press FACTORY DEFAULT in the Admin tab of the copier front
panel and reboot the controller. Wait until the controller
prints a Startup Page before you continue.
3 Configure the wireless (Wi-Fi) settings for the Cisco card as
appropriate for your wireless network (e.g. SSID, Network
Type and Transmit Power via the
ADMIN>WIRELESS
S
ETTINGS>WIRELESS buttons on the front panel). Ensure to
select either the Infrastructure or Ad Hoc network type as
desired.
4 If the Infrastructure network type was selected, verify the Wi-
Fi connection by viewing the transfer rate on the front panel.
The panel will indicate either Not Connected or display the
current transfer rate.
