Getting Started Teledyne API T801 NDIR CO2 Analyzer Operation Manual
26
Figure 3-2: Display Screen and Touch Control
The front panel liquid crystal display screen includes touch control. Upon
analyzer start-up, the screen shows a splash screen and other initialization
indicators before the main display appears, similar to Figure 3-2 above (may or
may not display
a Fault alarm). The lights on the display screen, herein referred
to as LEDs, indicate the Sample, Calibration and Fault states; also on the screen
is the gas concentration field (Conc), which displays real-time readouts for the
primary gas and for the secondary gas if installed. The display screen also shows
what mode the analyzer is currently in, as well as messages and data (Param).
Along the bottom of the screen is a row of touch control buttons; only those that
are currently applicable will have a label. Table 3-2 provides detailed information
for each component
of the screen.
ATTENTION
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Do not use hard-surfaced instruments such as pens to operate the
control buttons.
