Model 360E Instruction Manual APPENDIX A-5: M360E iDAS Parameters Revision G.4
Table A-6: M360E iDAS Functions, Revision G.4
NAME DESCRIPTION UNITS
DETMES Detector measure reading mV
DETREF Detector reference reading mV
RATIO M/R ratio. None
SLOPE1 Slope for range #1 None
SLOPE2 Slope for range #2 None
OFSET1 Offset for range #1 None
OFSET2 Offset for range #2 None
ZSCNC1 Concentration for range #1 during zero/span calibration, just before computing
new slope and offset
PPM
ZSCNC2 Concentration for range #2 during zero/span calibration, just before computing
new slope and offset
PPM
CONC1 Concentration for range #1 PPM
CONC2 Concentration for range #2 PPM
STABIL Concentration stability PPM
BNTEMP Bench temperature
°C
WTEMP Wheel temperature
°C
SMPTMP Sample temperature
°C
SMPFLW Sample flow cc/m
SMPPRS Sample pressure "Hg
BOXTMP Internal box temperature
°C
PHTDRV Photometer detector temperature drive mV
TEST7 Diagnostic test input (TEST_INPUT_7) mV
TEST8 Diagnostic test input (TEST_INPUT_8) mV
TEMP4 Diagnostic temperature input (TEMP_INPUT_4)
°C
TEMP5 Diagnostic temperature input (TEMP_INPUT_5)
°C
REFGND Ground reference (REF_GND) mV
RF4096 4096 mV reference (REF_4096_MV) mV
BNCDTY Bench temperature control duty cycle Fraction
0 = off,
1 = on
WHLDTY Wheel temperature control duty cycle Fraction
05233 Rev G.4 A-29
