INSTEON KeypadLinc V2 Dimmer User’s Guide
SPECIFICATIONS
KeypadLinc Dimmer Specifications
General
Smarthome Product Number 2486D, INSTEON KeypadLinc V2 Dimmer Switch
Warranty 2 years
Operation
On-Levels 32
Ramp Rates
(full-ON to full-OFF)
0.125 to 9 seconds if programmed locally,
0.125 seconds to 9 minutes if programmed remotely
LED Single LED at bottom of unit, indicates supplied power and signals programming
cues
Manual Operation Modes INSTEON only, X10 only, INSTEON and X10 Combo Mode
Combo Mode Message Order INSTEON, X10, INSTEON cleanup
Multi-Way Circuit Support One KeypadLinc Dimmer controls load,
Cross-Link any number of KeypadLinc Dimmers or other INSTEON Controllers
Setup Memory Non-volatile EEPROM
INSTEON Features
INSTEON Addresses 1 hard-coded out of 16,777,216 possible
INSTEON Links 417 out of 16,777,216 possible
INSTEON Powerline Frequency 131.65 KHz
INSTEON Minimum Transmit Level 3.2 V
pp
into 5 Ohms
INSTEON Minimum Receive Level 1 mV
pp
nominal
INSTEON Messages Repeated Yes
X10 Features
X10 Primary Address 1 optional (comes unassigned)
X10 Scene Addresses 255 possible
X10 Status Response Supported
X10 Resume Dim Supported (by setting Local On-Level to zero)
X10 Powerline Frequency 121 KHz
X10 Minimum Transmit Level 3.2 V
pp
into 5 Ohms
X10 Minimum Receive Level 20 mV
pp
nominal
X10 Messages Repeated No
Page 36 of 38
