INSTEON KeypadLinc V2 Dimmer User’s Guide
HOW TO USE KEYPADLINC DIMMER
Using the Buttons
The On Button makes your light go ON and the Off Button makes your light go OFF.
• Tap the On Button to make your light go at the Local Ramp Rate from whatever brightness it currently
has to the Local On-Level brightness.
• Tap the Off Button to make your light go at the Local Ramp Rate from whatever brightness it currently
has to full-OFF.
• Double-tap the On Button to make your light go full-ON quickly.
• Double-tap the Off Button to make your light go full-OFF quickly.
• Press and hold the On Button to gradually brighten your light from whatever brightness it currently
has to full-ON.
• Press and hold the Off Button to gradually dim your light from whatever brightness it currently has to
full-OFF.
Button Tap Double Tap Press and Hold
On
Ramp to On-Level Fast ON Brighten
Off
Ramp to OFF Fast OFF Dim
Using the Air Gap
Pulling the SET Button at the bottom of the switch out as far as it will go (about 1/8”) opens mechanical
contacts that remove all power from KeypadLinc Dimmer and the load that it controls. “Air gapping” can
be useful for replacing bulbs or any other time you want the controlled circuit to be unpowered.
Because KeypadLinc Dimmer’s settings are stored in non-volatile memory, setup information will not be
lost when the unit unpowered.
BE CAREFUL
If you press the SET Button in too far when you undo the air gap, you might inadvertently rese
KeypadLinc V2 Dimmer to its factory default settings. Just push the button in until its top is even with
the Trim Frame.
Page 30 of 38
