INSTEON KeypadLinc V2 Dimmer User’s Guide
10. Cap the other TRAVELER wire. The other TRAVELER wire,
usually red, will not be used, so put a wire nut on the end of it.
11. Connect the KeypadLinc Primary’s LOAD Wire. Use a wire
nut to connect the LOAD wire, usually red, to the KeypadLinc
Primary’s red LOAD wire.
12. Connect the KeypadLinc Primary’s NEUTRAL and GROUND Wires. Follow the same instructions
as before in Steps 5 and 6 for the KeypadLinc Secondary.
13. Return to the installation instructions on page 8 and continue on with step 7.
Special Treatment for Four- or More-Way Circuits
If your lighting circuit includes more than two switches controlling a single set of lights, those extra
switches will have four wires connected to them. Two of the wires are TRAVELERS from the preceding
switch and the other two are TRAVELERS to the next switch in the chain. You will be converting the
black TRAVELER wires to LINE wires and replacing the old four-wire switches with KeypadLinc
Secondaries.
1. Connect the KeypadLinc Secondary’s LINE Wire. Use a wire nut to connect both black
TRAVELER wires to the KeypadLinc Primary’s black LINE wire.
2. Cap the Two Unused TRAVELERS. The other two TRAVELER wires, usually red, will not be used,
so put wire nuts on the ends of them.
3. Cap the red LOAD wire from the KeypadLinc Secondary. Put a wire nut on the end of the
KeypadLinc Secondary’s LOAD wire to ensure that it won’t connect to anything.
4. Connect the KeypadLinc Secondary’s NEUTRAL and GROUND Wires. Use the same instructions
given previously in Steps 5 and 6.
Page 14 of 38
