A SERVICE OF

logo

Unit 5: Printer Configuration
SATO MB2i Service Manual PN 9001145B Page 5-12
CRC (CYCLIC REDUNDANCY CHECK) MODE
Allows the operator to enable or disable the Cyclic Redundancy Check (CRC) for each received
print data when using wireless LAN or Bluetooth interface.
Refer to Figure 1-1 of the Introduction unit in this manual for dipswitch location.
Figure 5-7, CRC Check Mode
Choose Applicable Option
Enable CRC Check: (DSW = 1: OFF, 2: ON, 3: ON, 4: ON) + Cover Open + PRINT + POWER
Disable CRC Check: (DSW = 1: OFF, 2: ON, 3: ON, 4: ON) + Cover Open + FEED + POWER
Flashes green when saving
the Head Check setting.
Confirm setting is
complete.
Press POWER.
Flashes green when setting
completed.
Printer shuts down.