A SERVICE OF

logo

Unit 5: Printer Configuration
SATO MB2i Service Manual PN 9001145B Page 5-5
LABEL SENSOR SELECTION
This function allows for the determination of the sensor to be used to control label positioning
relative to the media type that will be used. The two options are; eye-mark and gap. This
selection can only be made through host interface using a RS232C cable.
Figure 5-2, Label Sensor Selection
POWER = OFF
Connect the printer to the
host with RS232C cable.
Printer shuts down.
Send printer operation
registration command
from the host and select
the desired label type.
Adjustment
successful?
Yes / No
Power off and
disconnect cable.
Print a label.