A SERVICE OF

logo

Open as PDF
next previous
32 ST60 Depth Instrument Owner’s Handbook
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
offset and reset keys to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows YES , but if
you want to retain the current values, ensure that the display shows
NO .
Leaving Dealer calibration
Hold down the depth and alarm keys for 2 seconds to save your settings, exit
Dealer calibration and resume normal operation.
81038_4.book Page 32 Wednesday, March 24, 2004 3:17 PM