Chapter 4: Calibration 29
To access the Intermediate calibration screens, hold down the depth and alarm
keys for approximately 4 seconds.
To set the instrument status:
1. Press the
depth key to select the Instrument status screen.
2. Press the
offset and reset keys simultaneously to enter adjust mode, then
press either
offset or reset to set the required status.
Note:
You must not allocate more than one MASTER depth instrument in any system.
3. Press the offset and reset keys simultaneously again, to leave the adjust
mode.
Leaving Intermediate calibration
Hold down the depth and alarm keys for 2 seconds to save your settings, exit
Intermediate calibration and resume normal operation.
Hold down and
for approximately 4 seconds
depth
alarm
Intermediate calibration
D4353-1
depth
Software
version
Instrument
status
81038_4.book Page 29 Wednesday, March 24, 2004 3:17 PM
