English
40 RECORDING
When all timer blocks are full, Timer programming and
VCR Plus+ programming cannot be accessed. For
clearing a timer block, see ‘How to clear a timer block.’
Timer recording with ’VCR Plus+’
A PlusCode is a number of up to eight digits, printed in
most TV guides next to the start time of a TV program.
It contains all the information you need for programming
a timer.
1 Press TIMER on the remote control.
2 Select ‘
VCR Plus
+
programming
’ with w/v (down
or up cursor.)
3 Press u (right cursor).
4 Use the 0-9 buttons to enter the entire PlusCode
number (up to eight digits) as printed in your TV
guide. If you make a mistake, press CLEAR.
5 Confirm with OK.
6 If the VCR Plus+ channel has not been set, the DVD
Recorder will ask you to enter the channel number.
Refer to a channel napping list. You may find this in
your TV Guide or newspaper. Use t/u (left or right
cursor) to select the correct channel, then conform
with OK.
‰ The timer programming information will appear
on the TV screen.
CH. Start End
